See page 26 for hookup information. In this example, FM has been selected. Also, unexpected characters may be dis- played when unsupported characters are received.
Page Using The Listening Modes Pressing this button again will select the previous lis- tening mode. In the Pure Audio and Direct listening modes, 32 kHz, The illustration shows which speakers are active in each listening mode with 7. Page 51 System playback is scalable from 5. The center speaker outputs the sound as it is, while reverb is applied to the sound output by the other speakers, giving presence to even mono material. Setup closes. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.
Processing for the Theater-Dimensional listening mode is based on this setting. Ideally, the front left and right speakers should be equidistant from the listening posi- tion and at an angle close to one of the three available settings. You can listen to the source while recording.
Page Advanced Setup Large full band. For those with a smaller diameter, specify Small default crossover Hz. The crossover frequency can be changed on page Small: Select if the surround back speakers are small.
Large: Select if the surround back speakers are large. None: Select if no surround back speakers are connected. You can set the volume level of each speaker so that all speakers can be heard equally at the listening position. This sec- tion explains how to enter the necessary remote control code for the component that you want to control e.
Number buttons Enter numbers. Page Troubleshooting If you have any trouble using the AV receiver, look for a solution in this section. Before you record important data, make sure that the material will be recorded cor- rectly. Page Specifications North American: 9. Models with voltage selector: Others: Page 70 Memo Page 71 Memo All rights reserved.
Page 75 The channel is selected. For example, to select channel 20, press 0, 2, 0, or 2, 0, [ENT]. See the previous section. Page 80 Memo All other trademarks are the property of their respective owners. Activation normally takes between 10 and 15 minutes, but during busy peak periods, you may need to leave the AV receiver turned on for up to an hour. Page 83 The channel is selected. Please wait. If this occurs often, check the XM antenna position with the Antenna Aiming feature.
If the issue persists, contact XM Listener Care. Page 88 Memo Show all. Print page 1 Print document 88 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the apparatus to its normal operation, E.
If the apparatus has been dropped or damaged in any way, and F. When the apparatus exhibits a distinct change in performance this indicates a need for service.
Object and Liquid Entry Never push objects of any kind into the apparatus through openings as they may touch dangerous volt- age points or short-out parts that could result in a fire or electric shock. The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases shall be placed on the apparatus.
Don't put candles or other burning objects on top of this unit. Batteries Always consider the environmental issues and fol- low local regulations when disposing of batteries. If you install the apparatus in a built-in installation, such as a bookcase or rack, ensure that there is ade- quate ventilation.
Leave 20 cm 8" of free space at the top and sides and 10 cm 4" at the rear. The rear edge of the shelf or board above the apparatus shall be set 10 cm 4" away from the rear panel or wall, creating a flue-like gap for warm air to escape. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance servicing instructions in the literature accompanying the appliance. Recording Copyright--Unless it's for personal use only, recording copyrighted material is illegal with- out the permission of the copyright holder.
If you cannot turn on the unit, contact your Onkyo dealer. Care--Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild deter- gent and water. Dry the unit immediately afterwards with a clean cloth. Don't use abrasive cloths, thin- ners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel let- tering.
AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the unit's rear panel e. The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable easily accessible at all times. Some models have a voltage selector switch for compatibility with power systems around the world.
Before you plug in such a model, make sure that the voltage selector is set to the correct voltage for your area. Before you plug in this model, make sure that the voltage selector is set to the correct voltage for your area. If it isn't, use a small screwdriver to set it as appropriate. For example, if the voltage in your area is volts, set the selector to "V. If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet.
Never Touch this Unit with Wet Hands--Never handle this unit or its power cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer. This is normal. For U. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor- dance with the instructions, may cause harmful interfer- ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured mark- ings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. If the power cord's plug is not suitable for your socket outlets, cut it off and fit a suitable plug.
Fit a suitable fuse in the plug. Specifications and oper- ation are the same regardless of color. TX-SR incorporates copyright protection tech- nology that is protected by U. Use of this copyright protection technology must be authorized by Macro- vision Corporation, and is intended for home and other limited consumer uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited. Use this adapter if your AC outlet does not match with the plug on the AV receiver's power cord.
Adapter varies from country to country. Audyssey 2EQ is a trade- mark of Audyssey Laboratories. This unit incorporates HDMI technology. All rights reserved. Thank you for purchasing an Onkyo AV Receiver. Please read this manual thoroughly before making. Following the instructions in this manual will enable. Playing your AV components Listening to the Radio Enjoying the Listening Modes Advanced Operation Install in.
Do not install near any heat sources such as radia-. Do not defeat the safety purpose of the polarized or. A polarized plug has two. A grounding. The wide blade or the third prong are pro-.
If the provided plug does not. Protect the power cord from being walked on or. Use only with the cart, stand,. Unplug this apparatus during lightning storms or. Servicing is required when the apparatus has been. Unplug the apparatus from the wall outlet and refer.
When the power-supply cord or plug is damaged,. If liquid has been spilled, or objects have fallen. If the apparatus has been exposed to rain or. If the apparatus does not operate normally by. Adjust only. If the apparatus has been dropped or damaged in.
When the apparatus exhibits a distinct change in. Never push objects of any kind into the apparatus. The apparatus shall not be exposed to dripping or.
Don't put candles or other burning objects on top of. Always consider the environmental issues and fol-. If you install the apparatus in a built-in installation,. Leave 20 cm 8" of free space at the top and sides. The rear edge of the shelf. The lightning flash with arrowhead symbol, within an.
0コメント